RIB-ROOF Speed 500 may alternatively be installed on full-surface supports. A variation in addition to the roof boardings is the high compressive strength mineral wool with high density top layer (application type DAA-dm according to DIN V 4108-10).

Installation of the profiles may either be done on distance profiles which correspond to the thickness of the thermal insulation or on the clip border – structure profiled or flat, which is fastened directly onto the support structure.
It is vital to avoid gaps when laying the insulating boards. This finish is also transferable to RIB-ROOF 465 if so-called pressure distribution profiles are used.


Areas of application of the clip border finish flat or profiled RIB-ROOF Speed 500:

You always use the flat clip border on full surface supports, e.g. shuttering or non-slip thermal insulation when the fastening screws can be placed in the erected clip and then in the subsequent webbed area of the profiled sheet and the screw heads thus disappear into the hollow space of the web.

WIf the trapezoidal profiles are installed on purlins from ridge to the eaves it is possible to use the flat clip border Speed 500 for special trapezoidal dimensions on high compressive mineral wool.

You use the profiled clip border on full surface supports such as non-slip thermal insulation when the clip border must (also) be fastened between the clips and the screw heads must disappear into the lateral cavity of the clip border. For optimal laying, the safe thermal insulation is milled out at the building site to the exact fit of the geometry of the profiled clip border with a mobile milling device. Should you place an order, the milling device which resembles a lawn mower will be supplied by us. If the profiled clip borders are needed on a length of more than 30 m, the clip borders have to be installed not one behind the other but moved a little bit or interrupted by turning, so that the expansion is guaranteed.